Mr. Coffee ECM10 Manuel d'instructions Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
76
BEFORE BREWING YOUR FIRST CARAFE OF ESPRESSO
Please refer to Page 5 for Diagram of Parts.
1. Turn the control knob to the “OFF” position and make sure that the appliance is unplugged
from the electrical outlet.
2. First remove and then wash the carafe, lid, filter basket and filter holder in a mixture of mild
detergent and water. Rinse each thoroughly and replace into the machine. See “How to Brew
Espresso” below for instructions on removal and replacement of filter basket and holder.
3. To clean the inside of the machine, follow steps for “How to Brew Espresso” below,
using water only. Do not immerse the appliance in water or attempt to reach any
internal parts of the machine.
HOW
TO BREW ESPRESSO
1. Turn the control knob to the “OFF” position.
2. Fill the glass carafe with cold water to the designated marking for the desired number of servings
of espresso or cappuccino. Never use warm or hot water to fill the water reservoir.
3. Remove the water reservoir cap and pour the water into the water reservoir.
Do not fill to the top of the reservoir or there will not be enough area to generate steam.
CAUTION:
Do not pour water into the tank while the appliance is on. Check to make sure
the control knob is in the “OFF” position.
4. Screw the cap back on top of the water reservoir. Make sure it is on tight.
P
REPARING THE
COFFEE
1. Place the filter basket in the filter holder. (See Figure 1)
2. Fill with fresh, fine ground espresso coffee to the 2 or 4 cup
mark of the filter basket. Do not fill above the 4 cup markings.
Clean any excess coffee from the rim of the filter holder.
This will assure proper fit under the brew head.
ATTENTION:
Do not tamp or compress coffee.
Do not overfill the filter basket.
This might cause clogging or overflow.
FIGURE 1
SERVINGS ESPRESSO CAPPUCCINO
2 2 Cup marking on carafe Midpoint between 2 and 4 cup mark
on carafe
4 4 Cup marking on carafe Top of metal band on carafe
(This symbol is on your unit)
LOCK
ROTATE FILTER HOLDER
TO
HERE
3. Place the filter holder underneath the brew head
so that the handle is positioned to the left of center.
(See Figure 2) Lift the filter holder up and insert
into the brew head. Rotate handle completely to the
right until it stops at the “LOCK” position.
Make sure the filter holder is secure.
(See Figure 2)
BREWING ESPRESSO
ATTENTION: IF YOU ARE PLANNING TO MAKE
CAPPUCCINO,
PLEASE REFER TO THE NEXT SECTION
“HOW TO MAKE CAPPUCCINO.
1. Make sure the drip grid is in place on the drip tray.
2. Place the cover on the carafe so the lid opening faces the spout,
and set it on the drip tray. The filter holder nozzle should rest
above the aperature of the decanter lid.
3. Make sure the control knob is in the OFF position.
4. Plug the power cord into an electrical outlet and rotate the
control knob upward to the “cup” symbol, which begins
the brewing process. The light will illuminate to let you know
that the machine is on. (See Figure 3)
5. Espresso will begin to flow into the carafe in about three minutes.
6. When the espresso has stopped flowing into the carafe, turn the
control knob to the “OFF” position. Unplug the power cord and
allow the machine to cool. Do not remove reservoir cap until the
pressure in the machine has been released. Follow procedures
in section marked
“C
AUTION:PRESSURE
on Page 3.
C
AUTION
:
D
o not remove reservoir cap or filter holder at any time while the
appliance is under pressure or until the appliance has cooled down. Follow the
procedures marked
“CAUTION: PRESSURE
on Page 3 to relieve the pressure
before removing the reservoir cap or filter holder.
7. After the machine has cooled down and all pressure has been relieved, remove the filter holder
from the brew head. Using the filter retainer clip to secure the filter basket in the filter holder,
turn the filter holder upside down to empty. Rinse the filter basket and holder with water.
C
AUTION
:
The metal parts of the filter holder might still be very hot. Make sure
to use the filter retainer clip when discarding the grounds. Cool these parts by
running under cold water.
8. For cleaning instructions, refer to Page 9.
FIGURE 3
FIGURE 2
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire